Documentation - Redise Pack

A guide to Redise Pack installation, operation and administration

open all | close all

4.3.2 Replacing a failed master

When we’re running a group of Redis servers with replication and persistence, there may come a time when some part of our infrastructure stops working for one reason or another. Maybe we get a bad hard drive, maybe bad memory, or maybe the power just went out. Regardless of what causes the system to fail, we’ll eventually need to replace a Redis server. Let’s look at an example scenario involving a master, a slave, and needing to replace the master.

Machine A is running a copy of Redis that’s acting as the master, and machine B is running a copy of Redis that’s acting as the slave. Unfortunately, machine A has just lost network connectivity for some reason that we haven’t yet been able to diagnose. But we have machine C with Redis installed that we’d like to use as the new master.

Our plan is simple: We’ll tell machine B to produce a fresh snapshot with SAVE. We’ll then copy that snapshot over to machine C. After the snapshot has been copied into the proper path, we’ll start Redis on machine C. Finally, we’ll tell machine B to become a slave of machine C.3 Some example commands to make this possible on this hypothetical set of systems are shown in the following listing.

Listing 4.4 An example sequence of commands for replacing a failed master node
user@vpn-master ~:$ ssh root@machine-b.vpn
Last login: Wed Mar 28 15:21:06 2012 from ...

Connect to machine B on our VPN network.

root@machine-b ~:$ redis-cli

Start up the commandline redis client to do a few simple operations.

redis 127.0.0.1:6379> SAVE
OK
redis 127.0.0.1:6379> QUIT

Start a SAVE, and when it’s done, QUIT so that we can continue.

root@machine-b ~:$ scp 
> /var/local/redis/dump.rdb machine-c.vpn:/var/local/redis/
dump.rdb                  100%      525MB   8.1MB/s   01:05

Copy the snapshot over to the new master, machine C.

root@machine-b ~:$ ssh machine-c.vpn
Last login: Tue Mar 27 12:42:31 2012 from ...
root@machine-c ~:$ sudo /etc/init.d/redis-server start
Starting Redis server...

Connect to the new master and start Redis.

root@machine-c ~:$ exit
root@machine-b ~:$ redis-cli
redis 127.0.0.1:6379> SLAVEOF machine-c.vpn 6379
OK

Tell machine B’s Redis that it should use C as the new master.

redis 127.0.0.1:6379> QUIT
root@machine-b ~:$ exit
user@vpn-master ~:$

Most of these commands should be familiar to those who have experience using and maintaining Unix or Linux systems. The only interesting things in the commands being run here are that we can initiate a SAVE on machine B by running a command, and we later set up machine B to be a slave of machine C by running a command.

As an alternative to creating a new master, we may want to turn the slave into a master and create a new slave. Either way, Redis will be able to pick up where it left off, and our only job from then on is to update our client configuration to read and write to the proper servers, and optionally update the on-disk server configuration if we need to restart Redis.

REDIS SENTINEL

A relatively recent addition to the collection of tools available with Redis is Redis Sentinel. By the final publishing of this manuscript, Redis Sentinel should be complete. Generally, Redis Sentinel pays attention
to Redis masters and the slaves of the masters and automatically handles failover if the master goes down. We’ll discuss Redis Sentinel in chapter 10.

In the next section, we’ll talk about keeping our data from being corrupted by multiple writers working on the same data, which is a necessary step toward keeping our data safe.

3 Because B was originally a slave, our clients shouldn’t have been writing to B, so we won’t have any race conditions with clients writing to B after the snapshot operation was started.