Documentation - Redise Pack

A guide to Redise Pack installation, operation and administration

open all | close all

Multi-IP & IPv6

Redise Pack supports machines that have multiple IP addresses, some of which can be IPv6 type addresses.

RP related traffic can be logically and physically divided into internal traffic and external traffic:

  • “Internal traffic” refers to internal cluster communications, such as communications between the nodes for cluster management purposes.
  • “External traffic” refers to communications between the clients and the databases, as well as connections to the management UI in the browser.

When only one IP address exists on a machine that serves as a RP node, it is used for both internal and external traffic.

When more than one IP address exists on a RP node:

  • One of the IPv4 addresses is used for internal traffic
  • Other IP addresses may only be used for external traffic

As part of the node configuration process, if the machine has multiple IP addresses, you are required to assign one of the machine’s IPv4 addresses for internal traffic use, and assign one or more IPv4/IPv6 addresses for external traffic.

If at a later stage you would like to update the IP address allocation, run the relevant commands in rladmin command-line interface (CLI).

If you need to update the internal IP address in the OS, you must remove that node from the RP cluster, make the IP change, and then add the node back into the cluster.

When manually configuring an internal address for a node, make sure the address is valid and bound to an active interface on the node. Failure to do so will prevent the node from coming back online and rejoining the cluster.

When configuring external addresses, it is possible to list external addresses that are not bound to an active interface, but are otherwise mapped or configured to route traffic to the node (AWS Elastic IPs, a load balancer VIP and so on).

rladmin node address commands syntax:
node addr set
node external_addr set
node external_addr [ add | remove ]

Where:

  • addr – is the internal address (can be used only when the node is offline)
  • external_addr – is the external address(es)

Note: While Joining a new node to a cluster during the node bootstrap process, when prompted to provide an IP of an existing node in the cluster, if you use the node’s IP, provide the node’s internal IP address.